Change the Serpentine Belt on a 2002 Chevy TrailBlazer

Sponsored ADS

Change the Serpentine Belt on a 2002 Chevy TrailBlazer

Sponsored ADS


 

 

  • Step 1

    Pop the cap and loves the girdle routing diagram. The diagram on the 2002 Chevy Pioneer is to like on top of the fan mounting around the top of the radiator. The girdle routing diagram is a image of the serpentine girdle being conduit around the pulleys. This diagram give you the correct advance procedure for the new belt. If there is no serpentine girdle routing diagram, sudden rises the pen and scratch pad and aspiration out the hope direction in which the girdle is conduit around each one of the pulleys.

  • Step 2

    Locate the girdle tensioner under the alternator. The girdle tensioner is what catches the serpentine girdle onto the pulleys. The girdle tensioner have a 3/8-inch place hole close to the trashbags of it. insertion the place end of the 3/8-inch to offer bar in the 3/8-inch place hole on the girdle tensioner. Turn the girdle tensioner in the contrary direction of the needles of a watch to to relieve the tension on the belt. by-product the girdle off the girdle tensioner pulley, and off the to remain pulleys.

  • Step 3

    Route the new girdle around the crankshaft pulley first. The crankshaft pulley is the center pulley on the trashbags of the engine on the front.

  • Step 4

    Route the girdle around the to remain pulleys as directed by the girdle routing diagram. Leave the girdle tensioner pulley for last. This make it easier for you to by-product the new girdle on.

  • Step 5

    Insert the 3/8-inch to offer bar schedule into the girdle tensioner and turn it in the contrary direction of the needles of a watch to to relieve the tension. With your other hand, by-product the new girdle onto the girdle tensioner pulley. Release the girdle tensioner Automedia the belt. The girdle tensioner then Traction all the slackness out of the new girdle and to make it tight. To inspect the girdle to to make sure it is correctly seated in all the pulleys.

  • Step 6

    Crank the engine and To inspect the girdle again to to make sure it stays sat into the pulleys. Turn the engine off.


  • Sponsored ADS
     

    Change the Belt in a 1994 Jeep Grand Cherokee | Reset the Warning Lights on a 2005 Mazda RX8 | Change the Fuel Filter on a 2001 Silverado Truck | Headlamp Replacement Instructions for a 1995 Nissan Maxima | Determine If an Alternator or Starter Is Bad | Reset the ABS Light on a 2000 Ford Explorer | Replace a Headlight on a Jeep TJ | Change a Fan Belt on a 2000 VW Beetle | Buff Automobile Paint | Take the Roof Racks Off of a 2005 Chevy TrailBlazerReplace an Ignition Cylinder on a 1996 Ford Ranger | Remove a Headlight on a Sunfire | Change the Oil Pan Gasket on 1995 Ford Taurus | Steps to Wax a Car | Replace the Backup Lights on a Subaru Outback | Clean the Diodes on a Car Battery | Replace the Cabin Air Fliter in a 2005 Saturn Ion | Replace the Glass in a Side View Mirror | Fill Car Tires With Nitrogen | Replace the Rotors on a 1994 Honda | Remove a Scuff Mark on a Car | Replace the Battery in Your BMW Key | Remove a Cabin Air Filter on a 2007 DTS | Remove the Spare Tire on a Nissan Frontier | Use Automobile Jumper Cables